Low-Cost USB Rubber-Ducky Pentest tool

2019/10/15 | less than 1 minute read |

Summary

In this article I’ll describe how you can build for yourself (DIY) Rubber Ducky

The USB Rubber Ducky is a keystroke injection tool disguised as a generic flash drive. Computers recognize it as a regular keyboard and automatically accept its pre-programmed keystroke payloads at over 1000 words per minute.

Note: The same software can run on Digispark Develoment Board ($3.5).

What do we need:

  1. Setup Digispark Development Environment
  2. Turning Digispark into a Rubber Ducky Clone
  3. Troubleshooting

Setup Digispark Development Environment

Turning Digispark into a Rubber Ducky Clone

Troubleshooting

Leave a comment